Garage Door Garage Door Safety Inspections Martin, TN
Homeowners across Martin and the surrounding area call us for garage door safety inspections because we know Martin. The common drivers locally are swollen, sticking wood doors in summer humidity, moisture-tripped openers and sensors after storms, rusted bottom brackets on damp slabs, and mildew and rust on shaded, north-facing doors — and we fix the cause, not just the symptom.
Local climate is the quiet reason Martin doors fail when they do. Hot, humid summers and short, mild winters, with frequent storms and moisture that lingers in the air most of the year leads to mildew and moisture on shaded, north-facing doors, high year-round humidity that rusts springs, cables, and fasteners, and corrosion that creeps across hardware in the muggy air — all of it preventable with the right hardware.
The repair board in Martin fills up with the same culprits: swollen, sticking wood doors in summer humidity, moisture-tripped openers and sensors after storms, rusted bottom brackets on damp slabs, and mildew and rust on shaded, north-facing doors. Each is a one-visit fix with parts already on the truck.
Safety inspections are formal, documented evaluations of the entire garage door system — useful for home sales (preempt buyer-inspection negotiations), insurance audits (some carriers require periodic verification), post-incident review (after a near-miss or actual injury), and rental-property compliance. The inspection covers every safety-critical component plus structural items, and produces a signed PDF report that meets the documentation needs of most buyers, insurers, and property managers.
Our standard report covers: UL-325 compliance (photo-eyes present, aligned, and triggering auto-reverse on obstruction test), spring health (visible wear, age, cycle estimate), cable health (fray, corrosion, secure termination), drum and shaft integrity (set-screws tight, drums spooled correctly), opener motor and gear health (audible inspection, force/travel calibration), photo-eye function, manual-release operation, balance verification, and structural items (track alignment, bracket fasteners, panel integrity, hinge condition). Every check is photographed and the report includes the photographs.
Inspections take 60–90 minutes. The signed PDF is emailed within 4 hours of completion. If we find issues, we present a separate flat-rate quote for any repairs — you can address them during the same visit, schedule a return, or share the report with the relevant party (buyer, insurer, etc.) and decide later.